We offer a wide range of lathe accessories to make turning easier and more convenient. Some of our favorite lathe accessories include the spindle steady for supporting long, delicate spindles and large hollow forms to the Tool Caddy for keeping tools and accessories within easy reach to the swing away tailstock that eliminates the need to lift the tailstock off of the lathe when not in use.
JOHN in AR
I am fairly new to turning, but enjoy segmented vessels and hollowing. Too many times, turning at the top has caused vibration and resulted in a broken vessel rolling across my shop. No more! I just got this tonight and tried it out. What a difference! The turning is rock solid. Of course this is made with typical Oneway quality; it is a hefty device. My only complaint is that all the adjustments are operated with nuts (i.e., tools are required.). This isn't the biggest problem, but I've replaced two of the three nuts with knobs from a jig-building kit. The third one (which operates the clamping block) will require a different solution simply due to its size.Read All Reviews
I bought a next to new used Powermatic 3520B. The lathe had to be moved from one house to another. Used a trailer with a ramp, and two men moved the lathe up the ramp, used straps to hold it in place. drove it 10 miles, and then rolled in my garage. Lift and Roll made the move easy. Also, used at the club shop for demo set-up. Saved time and made it easy.Read All Reviews
Nigel in NY
I got tired of lifting the tailstock to remove it on my Nova lathe during bowl turning. This plus the bed extension is expensive but certainly will save your back. You can easily slide the tailstock out of the way after roughing the outside of a bowl. Then easily slide the banjo out of the way during sanding and finishing of a bowl. I did have to hone/lap the pieces to get the rails to the same height/width and remove burrs so the tailstock especially, and the banjo, would slide freely through the hinge onto the extension.Read All Reviews